Manitou MH25-4 T BUGGIE 4ST3A - E - Every 1000 Hours of Service or Two Years

E - EVERY 1000 HOURS OF SERVICE OR TWO YEARS
Carry out the operations described previously as well as the following operations.
E1 – FUEL TANK
CLEAN
Place the lift truck on level ground with the engine stopped.

IMPORTANT

Do not smoke or approach with a flame during this operation.
Never attempt to carry out welding or any other operation by yourself, as this could cause an explosion or a fire.
- Inspect the parts of the fuel circuit and the tank liable to leak, both visually and
by touch.
- In the event of a leak, contact your dealer.
- Place a container under drain plug 1 and unscrew the plug.
- Remove the filler plug 2 to ensure that the oil is drained properly.
- Rinse out with ten litres of clean diesel through filler port 3.
- Refit and tighten the drain plug 1 (tightening torque 29 to 39 N.m).
- Fill the fuel tank with clean diesel filtered through the filler port.
- Refit the filler plug 2.
- If necessary, bleed the fuel supply system (see: 3 - MAINTENANCE: G1 - FUEL SUPPLY
SYSTEM).
E2 – SAFETY DRY AIR FILTER CARTRIDGE
REPLACE
- For the disassembly and reassembly of the cartridge, see: 3 - MAINTENANCE: D1 -
DRY AIR FILTER CARTRIDGE.
- Remove the dry air filter safety cartridge 1 carefully, to minimise dust fall.
- Clean the gasket surface on the filter with a damp, clean lint-free cloth.
- Check the condition of the new safety cartridge before fitting (see: 3 - MAINTENANCE:
FILTERS AND BELTS).
- Introduce the cartridge into the filter axis and push it in, pressing the edges and
not the middle.
NOTE: The safety cartridge replacement frequency is given for information only.
The safety cartridge must be changed for every two changes of the air filter
cartridge.
3 - 22
1
3
2
1
647468 (26/11/2018)
M
SI 25/30/35 ... 4ST3A ; MH 25-4 ... 4ST3A