Manitou MH25-4 T BUGGIE 4ST3A - Page 97

G2 – WHEEL
REPLACE

IMPORTANT

In the event of a wheel being changed on the public highway, secure the lift truck vicinity:
- Stop the lift truck, if possible on firm, level ground.
- To pass on stop of lift truck (see: 1 - OPERATING AND SAFETY INSTRUCTIONS: DRIVING INSTRUCTIONS UNLADEN AND
LADEN).
- Switch on the hazard warning lights (OPTION).
- Immobilise the lift truck in both directions on the axle opposite to the wheel to be changed.
- Unlock the nuts of the wheel to be changed.
FRONT WHEEL
- Lift the carriage and tilt the mast backwards.
- Immobilize under the foot of the mast on the side where the wheel is being changed.
- Tilt the mast forwards to lift the wheel.
- Place wedges under the chassis as near as possible to the wheel.
- Completely unscrew the wheel nuts and remove them.
- Free the wheel by reciprocating movements and roll it to the side.
- Slip the new wheel on the wheel hub.
- Hand-tighten the nuts, grease them if necessary.
- Remove the wedges under the axle and lower the lift truck.
- Tighten the wheel nuts with a torque wrench (see: 3 - MAINTENANCE: A - DAILY
OR EVERY 2000 HOURS OF SERVICE OR 2 YEARS for tightening torque).
REAR WHEEL
For this operation, we advise you to use the hydraulic jack MANITOU Part number 505507.
- Place the jack under the counterweight. It must be situated in the middle and
under the flat part of the counterweight.
- Lift the wheel until it comes off the ground and put in place the safety block under
the axle.
- Completely unscrew the wheel nuts and remove them.
- Free the wheel by reciprocating movements and roll it to the side.
- Slip the new wheel on the wheel hub.
- Hand-tighten the nuts, grease them if necessary.
- Remove the security block and lower the lift truck with the jack.
- Tighten the wheel nuts with a torque wrench (see: 3 - MAINTENANCE: A - DAILY
OR EVERY 2000 HOURS OF SERVICE OR 2 YEARS for tightening torque).
3 - 29
647468 (26/11/2018)
M
SI 25/30/35 ... 4ST3A ; MH 25-4 ... 4ST3A