Manitou MHT 790 104JD H ST4 S1 - Instructions for Using as a Loader; A - Loading

1 - 20
INSTRUCTIONS FOR USING AS A LOADER
A - LOADING
p
You must not raise the boom if you have not checked the transverse attitude
of the telehandler (e INSTRUCTIONS FOR HANDLING A LOAD: D - TRANSVERSE
ATTITUDE OF THE TELEHANDLER).
REMINDER: Make sure that the following operations can be performed with good
visibility (e OPERATION INSTRUCTIONS UNLADEN AND LADEN: D
- VISIBILITY)�
FILLING THE BUCKET
- Place the bottom of the bucket in a horizontal position, barely touching the ground
(1) (fig� A1)�
- Move forward gradually (2) while raising the boom and tilting the bucket backwards
(3), for better filling and more extraction force (fig� A1)�
- Back up the telehandler (1) very carefully and gently to release the bucket� Lower
the boom (2) into the transport position (fig� A2)�
p
Tilt the bucket suciently back to avoid spilling product and ensure its stability
(loss of product under braking).
LOADING A TRAILER
- Approach the side of the trailer in the transport position (fig� A3)�
- Raise and extend the boom (1) (2) until the bucket is above the trailer, while
monitoring the longitudinal stability limiter and warning device (e INSTRUCTIONS
FOR HANDLING A LOAD: C - LONGITUDINAL STABILITY LIMITER AND WARNING
DEVICE) (fig� A4)�
- Drive the telehandler forward (3) very carefully and gently so that the bucket
empties its load at the centre of the trailer (fig� A4)�
- Apply the parking brake and place the forward/reverse selector in neutral�
- Slowly discharge the material (4) (fig� A4)�
- Tilt back the bucket (1) and reverse the telehandler (2) very carefully and gently
(fig� A5)�
- Retract (3) and lower the boom (4) into the transport position (fig� A5)�
2
3
3
1
A1
2
1
A2
A3
2
3
4
1
A4
4
3
2
1
A5
www.duma-rent.com