2-32
6 - CONTROL AND SIGNAL LIGHTS PANEL
CONTROL INSTRUMENTS
A - FUEL LEVEL
Only for MI .. D
Zone A1 indicates that you are using the reserve supply and that
time of use is limited.
B - ENGINE WATER TEMPERATURE
Zone B1 (0° to 50°) Use the lift truck with moderation, wait for
temperature to increase before normal
operation.
Zone B2 (55° to 105°) Use lift truck normally.
Zone B3 (110°) Use lift truck with moderation, monitor the temperature.
Zone B4 (120°) Stop the lift truck, look for the cause of overheating.
C - HOUR METER
D - GREEN LEFT-HAND INDICATOR LIGHT
E - GREEN RIGHT-HAND INDICATOR LIGHT
SIGNAL LIGHTS
NOTE:
,
Only for MI .. D
When activating the electrical system of the lift truck, all the ,
, , and indicator lamps must light to indicate their
correct operation. If one of the red lamps or the buzzer is not working,
carry out the necessary repairs.
BATTERY LOAD LAMP
If this lamp comes on while the lift truck is in operation, switch off the engine immediately, seek the cause of the electrical system
fault and check the alternator belt. Consult your dealer if necessary.
ENGINE OIL PRESSURE LAMP
If this lamp comes on while the lift truck is in operation, switch off the engine immediately, seek the cause of the engine fault and
check the engine’s oil level. Consult your dealer if necessary.
WATER IN FUEL FILTER LAMP
(Only for MI .. D)
If this lamp comes on while the lift truck is in operation, switch off the engine immediately and carry out the necessary repairs.
(see: 3 - MAINTENANCE: SERVICING SCHEDULE).
ENGINE PREHEATING LAMP
(Only for MI .. D)
Preheating is necessary. When the lift truck is switched on, the lamp comes on for a few seconds and goes out as soon as
preheating is ended. Start the lift truck’s engine.
PARKING BRAKE LAMP
This lamp comes on when the parking brake is applied.
TRANSMISSION OIL TEMPERATURE LAMP
If this lamp comes on while the lift truck is in operation, switch off the engine immediately, seek the cause of the transmission
fault and check the transmission oil level. Consult your dealer if necessary.
FAULT WARNING LAMP
If this lamp comes on while the lift truck is in operation, a diagnostic fault has been detected.
E.g.: The lamp will light if the driver vacates the driver’s seat while the forward/reverse selector is engaged.
NEUTRAL INDICATOR LAMP
The lamp will light when the forward/reverse selector is in neutral and the lift truck is stationary. This lamp must be lit in order to
start the engine.
UNUSED LAMP
C
A
B
D E
A1
B2 B4B3B1
To Next Page
Loading...
