Manitou MI 18 G - Every 500 Hours of Service

3-22
D - EVERY 500 HOURS OF SERVICE
Carry out the operations described previously as well as the following operations.
D1 - DRY AIR FILTER CARTRIDGE
CHANGE
MI 15/18 D
MI 15/18 G
Pre-filtration cartridges are available for use in a heavily dust laden atmospheres (see: 3 -
MAINTENANCE: FILTERS CARTRIDGES AND BELTS). The cartridge checking and cleaning interval
must also be reduced (to 250 hours in a heavily laden dust atmosphere and with pre-filtration).
Change the cartridge in a clean location, with the engine stopped. Never operate the lift truck with the air filter
removed or damaged.
- Raise the engine cover (see: 2 - DESCRIPTION: INSTRUMENTS AND CONTROLS).
- Release the bolts 1 (fig. D1/1) and remove cover 2 (fig. D1/1).
- Untighten the nut 3 (fig. D1/2) and free the filter cartridge 4 (fig. D1/2).
- The following parts must be cleaned with a damp, clean lint-free cloth.
- The inside of the filter and cover.
- The inside of the filter inlet hose.
- The gasket surfaces in the filter and in the cover.
- Check pipes and connections between the air filter and the engine.
- Before mounting check the state of the new cartridge (see: 3 - MAINTENANCE: FILTERS
CARTRIDGES AND BELTS).
- Insert the cartridge in the filter and refit the cover.
D1 - DRY AIR FILTER CARTRIDGE
CHANGE
MI 20/25/30/35 D
MI 20/25/30/35 G
Pre-filtration cartridges are available for use in a heavily dust laden atmospheres (see: 3 -
MAINTENANCE: FILTERS CARTRIDGES AND BELTS). The cartridge checking and cleaning interval
must also be reduced (to 250 hours in a heavily laden dust atmosphere and with pre-filtration).
Change the cartridge in a clean location, with the engine stopped. Never operate the lift truck with the air filter
removed or damaged.
- Raise the engine cover (see: 2 - DESCRIPTION: INSTRUMENTS AND CONTROLS).
- Release the bolts 1 (fig. D1/1) and remove cover 2 (fig. D1/1).
- Gently remove the cartridge 3 (fig. D1/2), taking care to avoid spilling the dust.
- Leave the safety cartridge in place.
- The following parts must be cleaned with a damp, clean lint-free cloth.
- The inside of the filter and cover.
- The inside of the filter inlet hose.
- The gasket surfaces in the filter and in the cover.
- Check pipes and connections between the air filter and the engine.
- Before mounting check the state of the new cartridge (see: 3 - MAINTENANCE: FILTERS
CARTRIDGES AND BELTS).
- Introduce the cartridge into the filter axis and push it in, pressing the edges and not the middle.
- Refit the cover 2 (fig. D1/1).
D1/2
3
D1/1
2
1
1
D1/1
1
1
2
D1/2
3
4
647377 (31/03/2014)