MACHINE OPERATION
3.
51647852EN-USM1(B-12/2021)
3. MACHINE OPERATION
3.1. INSTALLATION AT THE
DRIVER'S CAB
3.1.1 GETTING ON/OFF THE
MACHINE
CAUTION
Risk of injury
Do not jump out of the lift truck.
NOTICE
Risk of machine damage
Do not use the steering wheel as point of support.
Always face the lift truck when getting into and
out of the driver’s cab.
Always enter the driver's cab on the left side of
the machine.
Make sure that you always have 3 points of
support when getting in and out of the driver’s
cab.
• Use the driving seat access handle.
• Use the step.
• Use either the engine cover, the driver’s seat or the
overhead guard as third point of support.
3.1.2 ADJUSTING THE SEAT
CAUTION
Risk of injury and crushing the hand
Support the back-rest when adjusting the seat.
Be careful when adjusting the seat.
The driver is sitting on the driver’s seat.
Weight adjustment
1. Pull the weight adjustment lever fully out.
Figure 19: Driver’s seat weight adjustment
2. Move the weight adjustment lever up to increase the
weight or down to reduce it.
There are ten possible positions
between the min. and max. weights.
Before each run, return the lever to the
central position.
The max. or min. position is indicated
by a freely traveling lever.
The driver's weight is correctly adjusted
when the arrow is in the center of
indicator.
3. After completing weight adjustment, fully lower the
lever.
Longitudinal adjustment
• Adjust the locking lever until you reach the position
required.
To Next Page
Loading...
