MACHINE OPERATION
3.
55647852EN-USM1(B-12/2021)
Figure 27: Gear selector on the mini-levers
• Neutral position
1. Stop the machine.
2. Move the switch to position (1).
• Forward drive position
1. Stop the machine.
2. Move the switch to position (2).
• Reverse drive position
1. Stop the machine.
2. Move the switch to position (3).
The reversing lights are on and the audible
reverse warning is on.
3.2.1 Operating the machine with the operator
presence system, page 53
3.2.8.3 Driving the machine
1. Get on the machine
2. Adjust the seat
3. Adjust the steering wheel
4. Fasten the seat belt
5. Release the parking brake
6. Power up the machine
7. Operate the gear selector to move forwards or
backwards
3.2.8.4 Operating the lights and indicators
Positions (2) and (3) can be used without
switching on the ignition
• Put the Switch in position (1) and the lever in central
position
Figure 28: Lights and indicators
• The lights and indicators are off
• Put the switch in position (2)
• The sidelights and the rear lights are on
• Put the switch in position (3)
• The headlights and the rear lights are on
• Push the lever (4) upwards
• The left hand indicator lights flash
• Push the lever (4) downwards
• The right hand indicator lights flash
3.2.8.5 Operating the windscreen wipers
• Press on the desired windscreen wiper switch
The location of the switches may vary
depending on the options
The desired windscreen wipers are working
3.2.9 HANDLING A LOAD
3.2.9.1 Instructions for Handling a Load
Choice of Attachments
• Only attachments approved by MANITOU can be
used on its lift trucks.
• Make sure the attachment is appropriate for the
work to be done.
• Make sure the attachment is correctly installed and
locked onto the lift truck carriage.
• Make sure that your lift truck attachments work
properly.
To Next Page
Loading...
