MACHINE OPERATION
3.
61647852EN-USM1(B-12/2021)
The parked regeneration and engine default indicator
lamp are lit on the work page
Figure 32: Parked DPF regeneration decal
The fuel is at sufficient level
1. Put the gear selector in neutral position
2. Apply the parking brake
3. Rest the forks on the ground
4. Put the engine in idling speed
5. Enter the “Setting page” on the display screen
6. Enter the “Emissions” setting page
7. Launch the “DPF parking regeneration”
Stay close to the machine during the
exhaust regeneration
The duration of the regeneration
procedure is approximately 30 minutes
When finished, the remaining hours
before next regeneration will appear on
the screen
3.4. PARKING AND STORING
THE MACHINE
3.4.1 PARKING THE MACHINE
1. Move the machine to an approved parking location.
2. Set the wheels straight.
Block the wheels if the parking location
is on a slope.
3. Put the gear selector to neutral.
4. Set the parking brake on.
5. Lower the forks to the ground.
6. Turn off the engine and remove the key.
3.4.2 STORING THE MACHINE FOR
A SHORT DURATION
1. Wait for the machine to cool down.
2. Check the general state of the machine.
Report any damage to the machine.
3. Check the lubricants levels. Top-up the lubricants
levels if necessary.
3.5. TRANSPORT AND LIFTING
OF THE MACHINE
3.5.1 WINCHING/TOWING THE
MACHINE
NOTICE
Risk of excessive machine wear
While towing, steering and hydraulic assistance are
disabled.
Do not tow the machine at more than 25 km/h.
Operate the steering wheel and pedal slowly avoiding
sudden or jerky movements.
1. Place the gear selector in neutral position.
2. Release the parking brake.
3. Switch on the hazard warning lights.
4. Since there will be no steering or braking hydraulic
assistance, operate the steering wheel and pedal
slowly avoiding sudden or jerky movements.
3.5.2 LOADING/UNLOADING THE
MACHINE
WARNING
Ensure that the safety instructions connected to the platform
are respected before the loading of the machine and that the
driver of the means of transport is informed about the
dimensions and the weight of the machine.
To Next Page
Loading...
