80 647852EN-USM1(B-12/2021)
MAINTENANCE
1. Draining the oil
1.1.Raise the engine cover.
1.2.Place a container under drain plug (1) and
unscrew the plug.
1.3.Remove filler cap (2) in order to ensure that the
oil is drained properly.
Dispose of the drain oil in an
ecological manner.
2. Replacement of the filter
2.1.Remove engine oil filter (3); discard the filter and
the filter seal.
2.2.Clean the filter bracket with a clean, lint-free
cloth.
2.3.Lightly grease the new oil filter seal and fit the
new oil filter on the filter bracket.
Tighten the oil filter by hand pressure
only and lock the filter in place by a
quarter turn.
3. Filling up the oil
3.1.Refit and tighten drain plug (1).
3.2.Fill up with oil by filler port (4).
For this operation, we recommend
you use a funnel fitted with a hose.
3.3.Wait a few minutes to allow the oil to flow into the
sump.
3.4.Start the engine and let it run for a few minutes.
3.5.Check for possible leaks at the drain plug and the
oil filter.
3.6.Stop the engine, wait a few minutes and check
the level between the MAX and MIN marks on
dipstick (5).
3.7.Top up the level if necessary.
4.9.3 DRAIN FUEL WATER TRAP
The water trap serves to stop the water
contained in the fuel, it is incorporated within
the fuel filter.
1. Raise the engine cover.
2. Place a container under the fuel filter.
3. Undo the valve located under the filter by two or
three turns and operate the hand pump (1).
4. Retighten the valve.
4.9.4 ADJUST ALTERNATOR/FAN/
CRANKSHAFT BELT TENSION
1. Raise the engine cover.
2. Check the belt for signs of wear and cracks and
change if necessary.
3. Under pressure applied by the thumb (98 N), the
tension should be between 10 & 12 mm.
4. Adjust if necessary.
4.
To Next Page
Loading...
