MAINTENANCE
4.
85647852EN-USM1(B-12/2021)
4.1.Unscrew the hydraulic return oil filter (10) and
replace with a new one.
4.2.Refit the access panel (8).
4.3.Re-connect the hoses (6).
5. Filling up the oil
5.1.Clean and refit drain plug (1) (tightening torque
29 to 39 N.m).
5.2.Fill up with oil through filler port (11).
Use a clean container and funnel and
clean the underside of the oil drum
before filling.
5.3.Check the oil level on the dipstick (12).
5.4.Check for any possible leaks at the drain plug.
6. Hydraulic circuit decontamination
6.1.Let the engine run (accelerator pedal at halfway
travel) for 5 minutes without using anything on the
lift truck, then for 5 more minutes while using
completely the hydraulic movements (except the
steering system).
6.2.Accelerate the engine at full speed for 1 minute,
then activate the steering system.
6.3.This operation makes a pollution abatement of
the circuit possible through the hydraulic return oil
filter.
4.10.6 GREASE BRAKE PEDAL
AXLES
WARNING
In the event of prolonged use in an extremely dusty or
oxidizing atmosphere, reduce this interval to 500 hours of
service or every year. In case of technical faults, consult
your dealer.
1. Raise the engine cover.
2. Remove the floor mat.
3. Undo the screws (1) to remove the floor (2) .
4. Unscrew screws (3) to remove the floor (4) .
5. Unscrew screws (5) to remove the casing (6) .
6. Clean, then lubricate the lubricator (7) located at the
end of the brake pedal axle and remove any excess
grease.
To Next Page
Loading...
