2-34
11 - FORWARD/NEUTRAL/REVERSE GEAR SELECTION
When operating this control, the lift truck should be travelling at slow speed (less than 2 km/h)
and not accelerating. When the reverser is in the neutral position a mechanical lock prevents an
accidental shifting movement.
FORWARD: Lift slightly and push the lever forwards (position A).
REVERSE: Lift slightly and pull the lever backwards (position B).
NEUTRAL: To start the lift truck, the lever must be in neutral (position C).
NOTE: Reversing lights and an acoustic reversing alarm indicate that the lift truck is running in
reverse.
SAFETY FOR MOVING THE LIFT TRUCK
Authorisation to move the lift truck is controlled by an electronic unit. The operator must
observe the following sequence to move the truck forwards or backwards:
1 - sit down correctly in the driver’s seat,
2 - release the parking brake.
3 - engage forward or reverse movement.
To stop the lift truck, he must observe the following sequence:
1 - Set the forward/reverse selector to neutral.
2 - engage the parking brake,
3 - get out of the lift truck.
NOTE: If the operator leaves the driving cab with forward or reverse engaged the lift truck will stop after a short time. The operator must
then sit back in the seat, place the forward/reverse selector back in neutral and select forward or reverse in order to continue
advancing or reversing.
The lift truck can continue its movement if the operator sits back down before the lift truck stops.
12 - FUSES AND RELAYS UNDER THE ENGINE COVER
Always replace a faulty fuse with another of equivalent rating. Never use a fuse that has been repaired.
- Open the engine cover.
F1 - Starter (55A).
- Pre-heating (55A).
(Only for MI .. D)
F2 - Fuse box (55A).
A
B
C
F2
F1
To Next Page
Loading...
