Manitou MLT625-75 H S1-E3 - D - EVERY 500 HOURS SERVICE

3-23-200
C6 - FRONT AXLE DIFFERENTIAL OIL LEVELC6 - FRONT AXLE DIFFERENTIAL OIL LEVEL
CHECKCHECK
Place the lift truck on level ground Place the lift truck on level ground with the I.C. engine stopped.with the I.C. engine stopped.
- Remove level plug 1 (fig. C6). The oil should be flush with the edge of - Remove level plug 1 (fig. C6). The oil should be flush with the edge of the hole.the hole.
-- If necessary, add oil (see: 3 - MAINTENAIf necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS ANCE: LUBRICANTS AND FUEL) by the same hole.ND FUEL) by the same hole.
- Replace and tighten the level plug 1 (fig. C- Replace and tighten the level plug 1 (fig. C6)(tightening torque 34 to 496)(tightening torque 34 to 49 N.m)N.m)25-36 lbf/ft25-36 lbf/ft
C7 - REAR AXLE DIFFERENTIAL OIL LEVELC7 - REAR AXLE DIFFERENTIAL OIL LEVEL
CHECKCHECK
Place the lift truck on level ground Place the lift truck on level ground with the I.C. engine stopped.with the I.C. engine stopped.
- Remove level plug 1 (fig. C7). The oil should be flush with the edge of - Remove level plug 1 (fig. C7). The oil should be flush with the edge of the hole.the hole.
-- If necessary, add oil (see: 3 - MAINTENAIf necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS ANCE: LUBRICANTS AND FUEL) by the same hole.ND FUEL) by the same hole.
- Replace and tighten the level plug 1 (fig.- Replace and tighten the level plug 1 (fig.C7)(tightening torque 34 to 49C7)(tightening torque 34 to 49 N.m).N.m).25-36lbf/ft25-36lbf/ft
C8 - FRONT AND REAR WHEELS REDUCERS OIL LEVELC8 - FRONT AND REAR WHEELS REDUCERS OIL LEVEL
CHECKCHECK
Place the lift truck on level ground Place the lift truck on level ground with the I.C. engine stopped.with the I.C. engine stopped.
- Check the level on each wheel reducer.- Check the level on each wheel reducer.
- Place level plug 1 (fig. C8) in the horizontal position.- Place level plug 1 (fig. C8) in the horizontal position.
- Remove the level plug ; the oil should be flush with the - Remove the level plug ; the oil should be flush with the edge of the hole.edge of the hole.
-- If necessary, add oil (see: 3 - MAINTENAIf necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS ANCE: LUBRICANTS AND FUEL) by the same hole.ND FUEL) by the same hole.
- Refit and tight- Refit and tighten the level plug (ten the level plug (tightening torque 34 to 49ightening torque 34 to 49 N.m)N.m)25-36 lbf/ft25-36 lbf/ft..
22
C6C6
11
C7C7
11
C8C8
11

D - EVERY 500 HOURS SERVICE
D - EVERY 500 HOURS SERVICE
Carry out the operations described previously as well as Carry out the operations described previously as well as the following operations.the following operations.
D1 - I.C. ENGINE OILD1 - I.C. ENGINE OIL
DRAINDRAIN
D2 - I.C. ENGINE OIL FILTERD2 - I.C. ENGINE OIL FILTER
CHANGECHANGE
Place the lift truck on level ground, let the I.C. engine run at idle for a few minutes, thenPlace the lift truck on level ground, let the I.C. engine run at idle for a few minutes, then
stop the I.C. engine.stop the I.C. engine.
DRAINING THE OILDRAINING THE OIL
- Open the - Open the engine cover.engine cover.
- Remove access panel 1 (fig D1/1)- Remove access panel 1 (fig D1/1)
D1/1D1/1
11
https://www.forkliftpdfmanuals.com/