4-74-7
- Stop the I.C. engine and keep the ignition on the - Stop the I.C. engine and keep the ignition on the lift truck.lift truck.
-- Release the pressure from Release the pressure from the hydraulic circuit by the hydraulic circuit by pressing button 1 (fig. pressing button 1 (fig. E) downwardsE) downwards
4 or 5 times.4 or 5 times.
-- Connect the rapid connectors according to Connect the rapid connectors according to the logic of the the logic of the attachment’s hydraulicattachment’s hydraulic
movements.movements.
Make sure that the rapid Make sure that the rapid connectors are clean and protect the holes which are connectors are clean and protect the holes which are not used, with the capsnot used, with the caps
provided.provided.
HANHANDD RELRELEASEASINGING ANDAND DISDISCONCONNECNECTINTINGG THETHE AATTTTACHACHMENMENTT
-- Proceed in the reverse order of paragraph HAND LOCKING AND CONNECTINProceed in the reverse order of paragraph HAND LOCKING AND CONNECTING THE ATTG THE ATTACHMENTACHMENT
while making sure you put back the locking pin and while making sure you put back the locking pin and the clip in the bracket (fig. A).the clip in the bracket (fig. A).
LALAYINGYING ANAN AATTTTACHMEACHMENTNT
-- Proceed in the reverse order of paragraph TAKING UP AN ATTProceed in the reverse order of paragraph TAKING UP AN ATTACHMENT while making sureACHMENT while making sure
you place the attachment flat on the ground and you place the attachment flat on the ground and in closed position.in closed position.
EE
11
BB
CC
DD
To Next Page
Loading...
