REPLACEMENT OF THE FILTER
- Remove engine oil filter 3 discard the filter and the filter seal.
- Clean the filter holder with a clean, lint-free cloth.
- Fill the new engine oil filter (see: 3 - MAINTENANCE: FILTERS CARTRIDGES AND
BELTS) and lightly grease the seal.
- Fit the oil filter onto its holder.
- Tighten the oil filter by hand pressure only and lock the filter in place by a quarter
turn.
FILLING WITH OIL
- Refit and tighten the drain plug 1 (tightening torque 30 to 40 N.m).
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) through filler port 4.
NOTE: For this operation, we recommend you use a funnel fitted with a hose.
- Wait a few minutes to allow the oil to flow into the sump.
- Start the engine and let it run for a few minutes.
- Check for possible leaks at the drain plug and the engine oil filter.
- Stop the engine, wait a few minutes and check the level between the MAX and
MIN marks on the dipstick 5.
- Top up the level if necessary.
D4 – FUEL FILTER CARTRIDGE
REPLACE
- Lift up the overhead guard or the cab (see: 2 - DESCRIPTION: INSTRUMENTS AND
CONTROLS).
- Carefully clean the outside of the filter and its holder, to prevent dust from getting
into the system.
- Close the fuel valve 1 by setting to position B.
- Unscrew the retaining ring 2, remove the housing 3 and clean the inside using a
brush immersed in clean diesel oil.
- Discard the filter cartridge 4.
- Refit the assembly with a new cartridge (see: 3 - MAINTENANCE: FILTERS CARTRIDGES
AND BELTS).
3 - 19
3
5
A
B
1
4
2
3
647468 (26/11/2018)
SI 25/30/35 ... 4ST3A ; MH 25-4 ... 4ST3A
To Next Page
Loading...
