3 - 28
E6 – HYDRAULIC RETURN OIL FILTER CARTRIDGE
CHANGE
Place the lift truck on level ground with the engine stopped and the boom fully retracted
and lowered then remove the pressure from the circuits by acting on the hydraulic controls.
IMPORTANT
Thoroughly clean the outside of the filter and its surroundings before any intervention in order to prevent any risk
of polluting the hydraulic circuit.
- Lift out protective casing 1.
- Unscrew the fastening screws of the cover 2.
- Wait a few moments while the oil flows into the tank.
- Remove the hydraulic return oil filter cartridge 3 and replace with a new one
(see: 3 - MAINTENANCE: FILTERS CARTRIDGES AND BELTS).
- Make sure that the cartridge is correctly positioned and refit the cover 2.
- Refit the protective casing 1.
2
1
3
647104 (13/06/2016)
MT 835 / 1135 / 1335 ST3B
To Next Page
Loading...