Manitou MT 1135 ST3B - H5 - Front Headlights; H6

To Next Page

To Previous Page

3 - 39

H5 – FRONT HEADLIGHTS

ADJUSTING

RECOMMENDED SETTING

(as per standard ECE-76/756 76/761 ECE20)

Set to - 2% of the dipped beam in relation to the horizontal axis

of the headlamp.

ADJUSTING PROCEDURE

Place the unladen lift truck in the transport position and

perpendicular to a white wall on flat, level ground.

Check the tyre pressures (see: 2 - DESCRIPTION: FRONT AND REAR

TYRES).

Place the forward/reverse selector in neutral.

CALCULATING THE HEIGHT OF THE DIPPED BEAM (H2)

• h1 = Height of the dipped beam in relation to the ground.

• h2 = Height of the adjusted beam.

• l = Distance between the dipped beam and the white wall.

H6 – BATTERY FAILURE

CHANGE



IMPORTANT



Operate the battery cut-out no less than 30 seconds after having switched off the ignition with the ignition key.

Handling and servicing a battery can be dangerous, take the following precautions:

• Wear protective goggles.

• Keep the battery horizontal.

• Never smoke or work near a naked flame.

• Work in a well-ventilated area.

In the event of electrolyte being spilled onto the skin or splashed in the eyes, rinse thoroughly with cold water for

15minutes and call a doctor.

- Lift out protective casing 1.

- Change the battery 2.

-2%

h2 = h1 - (l x 2 / 100)

647104 (13/06/2016)

MT 835 / 1135 / 1335 ST3B

Manitou MT 1135 ST3B - H5 - Front Headlights; H6 - Battery Failure