Manitou MT 1135 ST3B - Unlocking the Function; Menu Screen

2 - 47
MENU SCREEN
- Press the button
to display the menu screen with the time and date. Navigate horizontally between menus using
the buttons
and vertically in the sub-menus using the buttons .
INFO
• Time and date (by default).
• Lift truck in degraded mode and/or fault detected (see error code table).
• “Check Maintenance” appears for a few seconds if maintenance is necessary.
CLOCK
• HOUR: Change the hour.
• DATE: Change the date.
• FORM: Change the time or date format.
LCD
• BACKL: Backlight.
• CONTR: Contrast.
OPT
The contents of this menu can be accessed by means of a customer password.
• RST H: Resetting of daily hour counter to zero, permitted (by default) or not permitted.
• PARK: Hand-operated parking brake or automatic (by default).
• CFLOW: Forced operation without driver presence permitted (by default) or not permitted.
• LLMC: Disabling of aggravating hydraulic movement cut-off permitted (by default) or not permitted.
• PASS: Fault override permitted (by default) or not permitted.
• UNIT: Speed of travel displayed in MPH or Km/h (by default).
• DIGI1: Digicode enabled (by default) or not enabled.
• DIGI2: Change the 4 figure digicode (lift truck start-up).
• CUST: Change the customer code.
DIAG
The contents of this menu enables your dealer to perform a diagnosis on the Man-Machine Interface.
XPRT
• RESET > HOURM: Reset the daily working hours counter to zero.
MAINT: Reset the maintenance interval to 500 hours.
OIL: Reset the engine oil maintenance to 500h (engine stopped).
• ADMIN > ADMIN: Change the administrator code.
• ERASE > MC: Clear faults from the computer of the Man-Machine Interface.
MP1: Clear faults from computer MP1.
MP2: Clear faults from computer MP2.
• CALIB > SECU: Enter the administrator code.
GAUGE: Recalibration of strain gauge.
BOOM: Boom angle calibration.
BRAKE: Brake pedal calibration (Inching mode OPTION).
UNLOCKING THE FUNCTION (if authorised)
- Validate with button
to unlock the fault.
Lock/unlock transmission fault.
Lock/unlock stabilizer fault.
MT 1135 ST3B / MT 1335 ST3B
Lock/unlock roll fault.
MT 1135 ST3B / MT 1335 ST3B
Lock/unlock hydraulic control fault.
Lock/unlock parking brake fault.
647104 (13/06/2016) MT 835 / 1135 / 1335 ST3B