Manitou MT 1135 ST3B - Telescoping; L.h. Stabiliser; R.h. Stabiliser; Tilting Corrector

2 - 57
MT 1135 ST3B
MT 1335 ST3B
• A - Lifting and tilting control lever.
• B - Telescoping control button.
• C - Left stabiliser control lever.
• D - Right stabiliser control lever.
• E - Tilting corrector control lever.
• F - Attachment control button.
LIFTING THE LOAD
- The lever A backwards when lifting.
- The lever A forwards when lowering.
TILT OF CARRIAGE
- The lever A to the left for reverse tilt.
- The lever A to the right for forward tilt.
TELESCOPING
- Button B forwards for extending.
- Button B backwards for retracting.
Only for MT 1335 ST3B
NOTE: When completely retracting the telescopes,
insistently operate the control so as to allow
all the telescopes to retract fully.
L.H. STABILISER
- Move lever C forwards to lower.
- Move lever C backwards to lift.
R.H. STABILISER
- Move lever D forwards for lowering.
- Move lever D backwards for lifting.
NOTE: The stabilisers can only be raised if the telescopic
sections are retracted and the lifting angle of
the boom is less than 62°.
TILTING CORRECTOR
- Move lever E to the left to tilt the lift truck to the left.
- Move lever E to the right to tilt the lift truck to the
right.
NOTE: The tilt correction may only be performed if
the lifting angle for the boom is less than 30°.
ATTACHMENT
- Button F forwards or backwards.
18 - ACCELERATOR PEDAL
19 - SERVICE BRAKE PEDAL
The pedal acts on the front and rear wheels by a power assisted hydraulic brake system, and allows the lift truck to be slowed
down and stopped.
N°310973
A
B
C
D
E
F
647104 (13/06/2016) MT 835 / 1135 / 1335 ST3B