Manitou MT 1335 ST3B - A - DAILY OR EVERY 10 HOURS SERVICE

3 - 10
A - DAILY OR EVERY 10 HOURS SERVICE
A1 – ENGINE OIL LEVEL
CHECK
Place the lift truck on level ground with the engine stopped, and let the oil drain into
the sump.
- Open the engine bonnet.
- Pull out dipstick 1.
- Clean the dipstick and check the correct level between the two notches.
- If necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) through
thefiller port 2.
- Visually check that there is no leakage or seepage of oil in the engine.
A2 – COOLING LIQUID LEVEL
CHECK
Place the lift truck on level ground with the engine stopped, and allow the engine to cool.

IMPORTANT

To avoid any risk of spraying or scalding, wait until the engine has cooled down before removing the cooling system
filler plug.
If the cooling fluid is very hot, add only hot cooling fluid (80 °C).
In an emergency, you can use water as a coolant. In such a case, the cooling system fluid should be changed soon
aspossible (see 3 - MAINTENANCE: F1 - COOLING LIQUID).
- Open the engine bonnet.
- The liquid must be at the MAXIMUM level on the expansion tank 1.
- If necessary, add cooling liquid (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL)
through the filler port 2.
- Visually check that there is no leakage in the radiator and pipes.
A3 – FUEL LEVEL
CHECK
Keep the fuel tank full, to reduce as much as possible any condensation due to the
atmospheric conditions.

IMPORTANT

Never smoke or approach with a flame during filling operations or when the tank is open.
Never refill while engine is running.
- Check the fuel gauge on the instrument panel.
- If necessary, add diesel fuel (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL).
- Open the fuel filler access panel with the ignition key.
- Remove cap 1.
- Fill the fuel tank with clean diesel filtered through the filler port 2.
- Refit the cap.
- Visually check that there is no leakage in the tank and pipes.
1
2
1
2
1
2
647104 (13/06/2016) MT 835 / 1135 / 1335 ST3B