Manitou MT 625 H 75K ST5 S1 - CHECK Hydraulic Oil Level; CHECK Windscreen Washer Liquid Level; Clean; Fuel Pre-Filter

3 - 16
1
2
3
3
2
1
1
2
CHECK Windscreen washer liquid level
- Open the protective casing1 with the ignition key.
- Visually check the level in tank2.
- If necessary add windscreen washer fluid (eLUBRICANTS AND FUEL).
- Remove cap3.
- Add windscreen washer liquid through filler port.
- Refit the cap.
CLEAN Fuel pre-filter
t
IMPORTANT
t
Carefully clean the outside of the pre-filter and its holder, to prevent dust from getting into the system.
- Open the engine cover.
- Disconnect electrical wiring harness1 from the fuel pre-filter.
- Place a receptacle under the drain plug2 and unscrew it by two thread turns.
- Allow the diesel fuel to flow out until it is free from impurities and water.
- Re-tighten drain plug2 and reconnect the wiring harness1.
CHECK Hydraulic oil level
Place the lift truck on level ground with the engine stopped, and the boom retracted
and lowered as far as possible.
t
IMPORTANT
t
Use a clean funnel and clean the underside of the oil drum before filling.
- Check dipstick1, the correct level must be at the level of the red dot.
- If necessary, add oil (eLUBRICANTS AND FUEL).
- Remove cap2.
- Add oil through filler port3.
- Refit the cap.
- Visually check that there is no leakage in the tank and pipes.
647732 (31/10/2019) MT 625 H 75K ST5 S1 / MT 625 H 75K COMFORT ST5 S1