Manitou MT 625 H 75K ST5 S1 - REPLACE Engine Oil; REPLACE Engine Oil Filter

3 - 19
1
5
6
3
4
2
REPLACE Engine oil *
REPLACE Engine oil filter *
Place the lift truck on level ground, let the engine run at idling speed for a few minutes,
then stop the engine.
t
IMPORTANT
t
Dispose of the drain oil in an ecological manner.
Tighten the oil filter by hand pressure only and lock the filter in place by a quarter turn.
DRAINING THE OIL
- Open the engine cover.
- Remove access panel1.
NOTE: When removing cover plates and hatches, clean the surrounding area and
remove any accumulations of flammable materials.
- Place a container under the drain hole and unscrew the drain plug2.
- Remove the filler plug3 to ensure correct drainage.
REPLACEMENT OF THE FILTER
- Unscrew and discard the engine oil filter4, together with its seal.
- Clean the filter bracket with a clean, lint-free cloth.
- Lightly oil the seal before refitting the new oil filter (
eFILTER ELEMENTS AND
BELTS) on its bracket (tightening torque11-12,5 ft-lbs15-17 N.m).
FILLING WITH OIL
- Refit and tighten the drain plug1.
- Fill up with oil (
eLUBRICANTS AND FUEL) through filler hole5.
- Wait a few minutes to allow the oil to flow into the sump.
- Start the engine and let it run for a few minutes.
- Check for possible leaks from the drain plug and the oil filter.
- Stop the engine, wait a few minutes and check the correct level between the two
marks on the dipstick6.
- Top up the level if necessary.
- Refit the access cover1.
* Only for the first50 hours of service and then every500 hours of service or1 year.
647732 (31/10/2019) MT 625 H 75K ST5 S1 / MT 625 H 75K COMFORT ST5 S1