Manitou MT 625 H 75K ST5 S1 - REPLACE Wheels

3 - 35
REPLACE Wheels
For this operation, we advise you to use the MANITOU hydraulic jack Part No.505507
and the MANITOU safety support prop Part No.554772.
t
IMPORTANT
t
In the event of a wheel being changed on the public highway, secure the lift truck vicinity:
- Stop the lift truck, if possible on firm, level ground.
- Stop the lift truck (e 1-OPERATING AND SAFETY INSTRUCTIONS: DRIVING
INSTRUCTIONS UNLADEN AND LADEN).
- Switch on the hazard warning lights.
- Immobilise the lift truck in both directions on the axle opposite to the wheel to
be changed.
- Unlock the nuts of the wheel to be changed.
- Place the jack under the flared axle tube, as near as possible to the wheel and
adjust the jack.
- Raise the wheel until it is clear of the ground and place the safety support under
the axle.
- Completely unscrew the wheel nuts and remove them.
- Free the wheel by reciprocating movements and roll it to the side.
- Slip the new wheel on the wheel hub.
- Hand-tighten the nuts, grease them if necessary.
- Remove the safety support and lower the lift truck with the jack.
- Tighten the wheel nuts with a torque wrench (
e 2000H-PERIODIC
SERVICE-EVERY2000 HOURS OF SERVICE OR EVERY4 YEARS) for the tightening
torque.
647732 (31/10/2019) MT 625 H 75K ST5 S1 / MT 625 H 75K COMFORT ST5 S1