Manitou MT 625 H 75K ST5 S1 - Safety Plates and Stickers

2 - 4
STOP
OFF
ON
30s
OFF
N°307508
N
°
234805
STOP
N°296998
N
°
234798
N° 52563320 N° 52563320
N° 52563320
4 4
3
5
6
7
8
9
2
10
1
3
4
N° 52563320
4
3
11
12
13
52588611
ATTACHMENT AND BOOM SAFETY:
Improper operating techniques can cause the
machine to tip over. Refer to machine load charts
and operator's manual for proper operating
techniques.
Refer to operator's manual for proper attach-
ments mounting and dismounting instructions.
Never use this machine as a manlift.
Attachment must be properly locked to the
carrier before raising boom.
Used only approved attachments on this
machine.
Do not work under raised boom or attachments
unless supported.
FAILURE TO FOLLOW ANY OF THE ABOVE
INSTRUCTION CAN CAUSE SERIOUS INJURY
TO THE OPERATOR OR OTHER PERSONS.
N° 52563320
3
4
SAFETY PLATES AND STICKERS
t
IMPORTANT
t
Clean all stickers and safety plates so that they are legible.
Any safety plates and stickers which are illegible or damaged must be replaced.
Check that stickers and safety plates are present after replacing any spare parts.
EXTERNAL PLATES AND STICKERS
REF. PART NO. DESCRIPTION
1 234805
- Hydraulic coupling instruction MT625 H COMFORT75K ST5
2 296998
- Maniscopic safety instruction
3 24653
- Slinging point
4 52563320
- Tie-down point
5 234798
- Hydraulic oil
6 288430
- Repairing instructions (on lift cylinder)
7 268491
- Brake fluid instruction
8 305405
- Diesel fuel
9 289013
- Towing instruction (OPTION)
10 307508
- Battery cut-off instruction
11 52631112 - Overall height (OPTION)
12 52588611 - Attachment and boom safety
13 52590031 - Attachment retaining shaft
647732 (31/10/2019) MT 625 H 75K ST5 S1 / MT 625 H 75K COMFORT ST5 S1