Manitou MT 625 H 75K ST5 S1 - Drivers Seat

2 - 21
1
2
3 - DRIVER'S SEAT
DESIGNED FOR MAXIMUM COMFORT, THIS SEAT CAN BE ADJUSTED AS FOLLOWS.
WEIGHT ADJUSTMENT
Adjust the weight when the driver is sitting on the seat.
- Pull the weight adjustment lever1 fully out.
- Move the weight adjustment lever1 upwards to increase the weight or downwards
to reduce it.
- There are ten possible positions between the min and max weights. Before each
run, return the lever to the central position. The max. or min. position is indicated
by a freely travelling lever.
- The driver's weight is correctly adjusted when the arrow is in the centre of indicator
lamp2.
- After completing the weight adjustment, fully lower the lever1.
NOTE: To avoid any health problems, it is recommended that the weight setting is
checked and adjusted before starting the lift truck.
LONGITUDINAL ADJUSTMENT
- Adjust the locking lever until you reach the position required. This then locks and
the seat will not shift into another position.
t
IMPORTANT
t
Only operate the lever by its recessed section and do not grasp from below, at the risk of crushing the hand.
LUMBAR ADJUSTMENT
This increases the comfort of the seat and the driver’s freedom of movement.
- Turn the handle to1 to adjust the height and depth of the lumbar support of the
upper part of the back-rest.
- Turn the handle to2 to adjust the height and depth of the lumbar support of the
lower part of the back-rest.
BACK-REST ANGLE ADJUSTMENT
- Support the back-rest, pull the lever and position the back-rest to find the desired
position.
t
IMPORTANT
t
If you do not support the back rest when making adjustments, it will tilt forwards.
MAINTENANCE
Dirt may adversely affect the correct functioning of the seat. For this reason, make sure
your seat is always clean.
- The cushions do not require to be removed from the seat frame for cleaning.
t
IMPORTANT
t
Accident risks are increased when the back-rest tilts.
First check the resistance of the fabric on a small concealed area before using any fabric
and plastic cleaner.
647732 (31/10/2019) MT 625 H 75K ST5 S1 / MT 625 H 75K COMFORT ST5 S1