Manitou MT 625 H 75K ST5 S1 - Man-Machine Interface (MMI)

2 - 23
RAZ
h
km/h
km/h
miles
mph
pm
°C
l/h
wait
notice
%
am
rpm
rpm
mph
!
8 - MAN-MACHINE INTERFACE (MMI)
• A-INSTRUMENT CONTROL PANEL
• B-SCREEN DISPLAYS
A-INSTRUMENT CONTROL PANEL
t
IMPORTANT
t
A permanently lit or flashing warning lamp, with the engine running, is the sign of an operating
fault. The lighting of some lamps may be accompanied by an audible signal. Do not ignore this
warning, consult your dealer without delay. If one of the warning lamps comes on while the lift
truck is in motion, stop the lift truck under the safest possible conditions.
REV COUNTER
10-level LED display from0 to3000 rpm.
ENGINE WATER TEMPERATURE
Temperature zones:
• 1 LED-(< 104 °F)or(< 40 °C) zone. Use the lift truck with moderation,
wait for temperature to increase before normal operation.
• 2 LEDs-(104 °F-140°F)or(40 °C-60 °C) zone.
• 3 LEDs-(140 °F-176°F)or(60 °C-80 °C) zone.
• 4 LEDs-(176 °F-185°F)or(80 °C-85 °C) zone.
• 5 LEDs-(185 °F-194°F)or(85 °C-90 °C) zone.
• 6 LEDs-(194 °F-203°F)or(90 °C-95 °C) zone from (104 °Fto203°F)or(40 °Cto95 °C) use the lift truck normally.
• 7 LEDs-(203 °F-221°F)or(95 °C-105 °C) zone. Use the lift truck with moderation.
• 8 LEDs- (221 °F-230°F)or(105 °C-110 °C) zone. Use the lift truck with moderation, ventilation control operating at
full speed.
• 9 LEDs-Red zone (230 °F-239°F)or(110 °C-115 °C).
• 10 LEDs-Red zone (>239°F)or(>115 °C) Stop the lift truck, seek the cause of overheating.
NOTE: If the red indicator lamp
and the buzzer come on (>230°F)or(> 110 °C) when the lift truck is running, stop the
engine immediately and seek the cause of the failure in the cooling system.
FUEL LEVEL
When only one LED is still displayed, the indicator lamp
comes on, indicating that you are using the reserve fuel supply
and that your operating time is limited.
FORWARD/NEUTRAL/REVERSE INDICATOR
eFORWARD/NEUTRAL/REVERSE GEAR SELECTION
AIR FILTER CLOGGING WARNING INDICATOR LAMP
The indicator lamp and buzzer come on when the air filter cartridge is clogged. When this indicator lamp remains on
continuously the cartridge needs changing. Stop the engine and carry out the necessary repairs (
e3-MAINTENANCE: FILTER
ELEMENTS AND BELTS).
HYDRAULIC OIL FILTER CLOGGING WARNING INDICATOR LAMP
The indicator lamp and the buzzer come on when the hydraulic oil filter cartridge is clogged. Stop the engine and carry out
the necessary repairs (
e3-MAINTENANCE: FILTER ELEMENTS AND BELTS).
GENERAL FAULT WARNING INDICATOR LAMP
If the lamp and the buzzer come on when the lift truck is running, stop the engine immediately and consult your dealer.
647732 (31/10/2019) MT 625 H 75K ST5 S1 / MT 625 H 75K COMFORT ST5 S1