EasyManua.ls Logo

Manitou MT 625 H 75K ST5 S1 - Accelerator Pedal; Forward;Neutral;Reverse Gear Selection; Service Brake Pedal and Transmission Cut-Off

Manitou MT 625 H 75K ST5 S1
136 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 - 34
18 - ACCELERATOR PEDAL
19 - SERVICE BRAKE PEDAL AND TRANSMISSION CUT-OFF
The pedal acts on the front wheels by means of a hydraulic brake system to slow down and stop the lift truck. During free
travel it enables the transmission to be cut off progressively thus allowing a gradual approach (delicate handling) with all the
engine power.
20 - FORWARD/NEUTRAL/REVERSE GEAR SELECTION
When changing the direction of travel, the lift truck should be travelling
at slow speed and not accelerating.
FORWARD: Push the switch forward (position A).
REVERSE: Tilt the switch backwards (position B). A reversing light and audible
reversing alarm indicate that the lift truck is travelling in reverse.
NEUTRAL: If indicator lamps
or are flashing, move the forward/
reverse selector back through neutral (position C).
SAFETY FOR MOVING THE LIFT TRUCK
Authorisation to move the lift truck is controlled by an electronic module.
The operator must observe the following sequence of operations to move
the truck forwards or backwards:
• 1-sit down correctly in the driver’s seat,
• 2-release the parking brake,
• 3-engage forward or reverse.
To stop the forklift truck, the following sequence must be observed:
• 1-set the forward/reverse selector to neutral,
• 2-engage the parking brake,
• 3-get out of the lift truck.
- If the operator leaves the driver's cab with forward or reverse engaged, the screen
will appear and generate
a sound alarm for two seconds. During this time, the operator can sit back down in the seat and continue advancing or
reversing. When this time is exceeded, the transmission will switch to neutral and the indicator lamps
or
will flash. The operator must sit back down and pass the forward/reverse selector back through neutral.
SAFETY FOR MOVING THE LIFT TRUCK
The operator must observe the following sequence to move the truck forwards or backwards:
• 1-sit down correctly in the driver’s seat,
• 2-release the parking brake,
• 3-engage forward or reverse.
A
B
C
647732 (31/10/2019)
MT 625 H 75K ST5 S1 / MT 625 H 75K COMFORT ST5 S1

Table of Contents

Related product manuals