Manitou MT 625 H 75K ST5 S1 - Air Conditioning Controls (Air Conditioning Option); Heater Control

2 - 36
A
B1
B2
B
C
A
B1 B2
B
22 - HEATER CONTROL
A-FAN CONTROL
This3-speed control allows the air to be ventilated through the air vents.
B-TEMPERATURE CONTROL
Adjusts the temperature inside the cab.
• B1-The fan pumps in the air at ambient temperature.
• B2-The fan pumps in warm air.
The intermediate positions allow the temperature to be adjusted.
23 - AIR CONDITIONING CONTROLS (AIR CONDITIONING OPTION)
MT625 H COMFORT75K ST5
t
IMPORTANT
t
The air conditioning only works if the lift truck has been started.
When using your air conditioning, it is essential to work with the cab closed.
In winter: So as to ensure that the air conditioning unit is correctly operated and completely efficient, start up the
compressor once a week, even for a short period of time, in order to lubricate the internal seals.
In cold weather: Warm the engine before switching on the compressor, in order to allow the coolant that has collected
in the liquid state at the lowest point of the compressor’s circuit to turn into gas under the effect of the heat given off
by the engine, as the compressor is liable to be damaged by coolant in the liquid state.
If your air conditioning does not seem to be working correctly, have it examined by your dealer.
Never try to repair any faults yourself.
A-FAN CONTROL
This3-speed control allows the air to be ventilated through the air vents.
B-TEMPERATURE CONTROL
Adjusts the temperature inside the cab.
• B1-The fan pumps in cold air.
• B2-The fan pumps in warm air.
The intermediate positions allow the temperature to be adjusted.
C-AIR CONDITIONING CONTROL
This control with a pilot light allows the air conditioning unit to be switched on.
HEATING MODE
The controls must be adjusted in the following way:
• C-Control with pilot light off.
• B-At the desired temperature.
• A-At the desired speed:1,2 or3.
AIR CONDITIONING MODE
The controls must be adjusted in the following way:
• C-Control with pilot light on.
• B-At the desired temperature.
• A-At the desired speed:1,2 or3.
DEMISTING MODE
The controls must be adjusted in the following way:
• C-Control with pilot light on.
• B-At the desired temperature.
• A-At speed3.
For optimum effectiveness, close the heating ventilators.
647732 (31/10/2019) MT 625 H 75K ST5 S1 / MT 625 H 75K COMFORT ST5 S1