LIFT TRUCK MAINTENANCE INSTRUCTIONS
GENERAL INSTRUCTIONS
- Ensure the area is sufficiently ventilated before starting the lift truck.
- Wear clothes suitable for the maintenance of the lift truck, avoid wearing jewellery and loose clothes. Tie back and protect
your hair, if necessary.
- Stop the engine and remove the ignition key, when an intervention is necessary.
- Read the operator's manual carefully.
- Carry out all repairs immediately, even if the repairs concerned are minor.
- Repair all leaks immediately, even if the leak concerned is minor.
- Ensure that process materials and of spare parts are disposed in all safely and in an ecological manner.
- Be careful of the risk of burning and splashing (exhaust, radiator, engine, etc.).
MAINTENANCE
- Perform the routine servicing ( MAINTENANCE) to keep your lift truck in good working condition.
- Failure to perform the routine servicing may invalidate the contractual warranty.
MAINTENANCE LOGBOOK
- The maintenance operations carried out in accordance with the recommendations given in the part (
MAINTENANCE)
and the other inspection, servicing or repair operations or modifications performed on the lift truck or its attachments
shall be recorded in a maintenance logbook.
- The entry for each operation should include the date of the work, the names of the individuals or companies who carried
it out, the type of operation and its frequency, if applicable.
- The part numbers of any lift truck items replaced shall also be indicated.
LUBRICANT AND FUEL LEVELS
- Use clean, recommended lubricants.
- Do not fill the fuel tank when the engine is running.
- Fill up the fuel tank only in areas provided for this purpose.
- Do not fill the fuel tank to the maximum level.
- Do not smoke or approach the lift truck with a flame, when the fuel tank is open or is being filled.
HYDRAULICS
- All work on the load handling hydraulic circuit is forbidden except for the operations described in the chapter (
MAINTENANCE).
- Do not attempt to loosen connections, hoses or a hydraulic component with the circuit under pressure.
IMPORTANT
It is dangerous to change the setting and remove the BALANCING VALVES or SAFETY VALVES which may be fitted to your lift truck cylinders.
The HYDRAULIC ACCUMULATORS that may be fitted on your lift truck are pressurised units. Removing these accumulators and their pipework is dangerous.
Such operations must only be performed by approved personnel (contact your dealer).
ELECTRICITY
- Do not short-circuit the starter relay to start the engine.
- Do not place metal items on the battery.
- Disconnect the battery before carrying out any work on the electrical circuit.
1-18
647737 M1 (A102020)
TMM ... ST5 S1
To Next Page
Loading...
