Manitou TMM 20 K ST5 S1 - DESCRIPTION (Standard); Drivers Cab Access; Drivers Seat; Ignition Switch

2 - DRIVER'S SEAT
DESIGNED FOR MAXIMUM COMFORT, THIS SEAT CAN BE ADJUSTED AS FOLLOWS.
LONGITUDINAL ADJUSTMENT
- Pull lever 1 upwards.
- Slide the seat assembly to achieve the desired driving position.
- Release the lever and be sure it returns to the lock position.
SEAT SUSPENSION ADJUSTMENT
- Turn control knob 2 to set the required flexibility.
BACKREST ANGLE ADJUSTMENT
- Turn control knob 3 to tilt the backrest to the required position.
MAINTENANCE
Dirt may adversely affect the correct functioning of the seat. This is why it is important to make sure that it is clean.
- First test the resistance of the coating on a small hidden area using everyday cleaner.
NB: As an option, there is a protective cover for transport.
3 - SEAT BELT
- Sit down correctly in the seat.
- Check that the seat belt 1 is not twisted.
- Place the seat belt at hip level.
- Attach the seat belt and check that it locks.
- Adjust the seat belt to your body shape without compressing your pelvis and
without excessive slack.

IMPORTANT

Under no circumstances must the lift truck be used if the seat belt is defective (fixing, locking, cuts, tears, etc.).
Immediately repair or replace the seat belt.
NB: If the belt is not properly locked, the lift truck will not be able to move in the
backward or forward direction. An alert appears (2-DESCRIPTION: SCREEN
DISPLAY - DESCRIPTION OF PAGES).
4 - IGNITION SWITCH
This switch has4 positions:
• P-Not used.
• O-Ignition switched off and engine stopped.
• I - Ignition and preheat
• II-Start-up and returns to position I as soon as the key is released.
NB: Remove the ignition key 1 before each wash and after each use of the lift truck.
1
DESCRIPTION (standard)
1 - DRIVER'S CAB ACCESS
- Getting into and out of the driver's cab.
- Use the three support points provided.
• A - Left handle.
• B - Steering wheel.
• C - Driver's cab step.
2-20
3
1
2
2
A
C
B
647737 M1 (A102020) TMM ... ST5 S1