Manitou TMM 20 K ST5 S1 - Switches

ENGINE OIL PRESSURE INDICATOR LAMP
If the indicator lamp and the buzzer come on when the lift truck is in operation,
immediately stop the engine and identify the cause (
oil level in the crankcase).
STEERING MODE CHANGE INDICATOR LAMP
TMM..4W

IMPORTANT

The operating fault indicator lamp flashes during the mode change.
The indicator lamp comes on when a steering mode change D1 (lateral) or D2
(frontal) is selected using the switch (-SWITCHES). The indicator lamp stays
on for the duration of the change cycle from one steering mode to another.
STEERING MODE OPERATING FAULT INDICATOR LAMP
If the lamp comes on when the lift truck is in operation or during a steering mode changeover, immediately stop the engine
and find the cause according to the following indications:
- 2 flashes: the forward/reverse selector is not in neutral during a steering mode change.

IMPORTANT

The steering mode can only be changed if:
- The forward/reverse selector is in neutral.
- The stabilisers are retracted.
- The parking brake is released (OFF).
- 3 flashes: the stabilisers are extended or not fully retracted.

IMPORTANT

If the mode change cycle is not performed correctly, the steering system will not work.
The indicator lamp
keeps flashing.
Return to the initial steering mode and start the procedure again (The wheel movements must be complete).
- 5 flashes: when changing to frontal mode, a front wheel alignment fault is detected.
NB: If a change of steering mode is not completed correctly, the operating fault indicator lamp flashes to start with and
then stays on. Restart a new cycle.
6 - SWITCHES
NB: The location of the switches may vary depending on the options.
PARKING BRAKE
This 3-position switch is also used to manage automatic braking of the lift truck.
A1
PARKING BRAKE IN AUTOMATIC MODE AND SWITCH INDICATOR LAMP
• The parking brake is active (ON) and the indicator lamp is lit on the instrument
panel when the lift truck is idling. As soon as the engine speed increases, the
indicator lamp goes out and the lift truck changes to brake release mode (OFF).
A2
PARKING BRAKE IN BRAKE RELEASE MODE (OFF)
• The indicator lamp is off.
A3
PARKING BRAKE ACTIVE (ON)
• The indicator lamp on the instrument panel is on.
P
A1
B1
A3
B2
A2
V1
V2
2-22
647737 M1 (A102020) TMM ... ST5 S1