Manitou TMM 20 K ST5 S1 - Coolant Level; Engine Oil Level; Lift Truck Environment

CHECK Lift truck environment

IMPORTANT

Follow the operator instructions (1-OPERATING AND SAFETY INSTRUCTIONS: OPERATOR INSTRUCTIONS).
- Carry out a general inspection of the lift truck:
• Fluid leaks or stains on the ground.
• Additional object on the lift truck or in the overhead guard or the cab.
• Mounting and adjustment of lights and rear view mirrors.
• Mounting and locking of the attachment.
• Condition of the tyres, to detect cuts, blisters, wear, etc.
- According to the conditions of use and the environment, ensure that the lift truck is clean:
• Lights, rear view mirrors, windows, bodywork.
• Driver's cab (OCCASIONAL MAINTENANCE).
• Engine housing and inside the frame to prevent leaks and build-up of materials (e.g. straw, flour, sawdust, organic
waste, etc.).

IMPORTANT

Particular attention should be paid to accumulations of flammable materials and fuel or lubricant leaks. These significantly increase the risk of fire.
CHECK Engine oil level
Place the lift truck on level ground with the engine stopped, and let the oil settle in
the sump.
- Open the engine cover.
- Pull out dipstick 1. Wipe it with a clean cloth and reinsert.
- Remove the dipstick. The level is correct when the engine oil is between the 2 marks.
- If necessary, add oil (LUBRICANTS AND FUEL) through the filler port 2. Wait 5
minutes for the oil to reach the crankcase before checking the level again.
- Visually check that there is no leakage or seepage.
CHECK Coolant level
Place the lift truck on level ground with the engine stopped, and allow the engine to cool.

IMPORTANT

To avoid any risk of spraying or scalding, wait until the engine has cooled down before removing the cooling system
filler plug.
In the event of an emergency, it is possible to use water as the coolant, but then proceed to drain the coolant circuit as
quickly as possible.
- Open the engine cover.
- Slowly turn the cap of the radiator 1 up to the safety stop.
- Allow the pressure and the steam to escape.
- Press down and turn the cap so as to release it.
- If necessary, add coolant (LUBRICANTS AND FUEL) up to 12mm below the filler
port.
- Visually check that there is no leakage in the radiator and pipes.
Â
10 H - DAILY SERVICE OR EVERY 10HOURS OF SERVICE
3 - 12
1
1
2
647737 M1 (A102020) TMM ... ST5 S1