CLEAN Dry air filter cartridge
Pre-filtration cartridges are available for use in very dusty atmospheres (FILTER CARTRIDGES AND BELTS). In this case, the
cartridge checking and cleaning interval must be reduced.
IMPORTANT
If the clogging indicator light comes on, this operation should be performed as soon as possible (maximum 1 hour).
Never operate the lift truck with the air filter removed or damaged.
Clean the cartridge in a clean place away from the air filter unit.
Protect your eyes during this operation.
Never clean the cartridge by tapping it on a hard surface.
Never wash the dry air filter cartridge.
Never clean the air filter safety cartridge. Replace it with a new one if it is clogged or damaged.
- For the dismantling and refitting of the cartridge (1000H: REPLACE Air filter cartridge).
- Leave the safety cartridge in place.
- Clean the filter cartridge from inside to outside using a compressed air jet (max. 2 bar), maintaining a safe distance (min.
30mm) to avoid damaging the cartridge.
- Use a damp, clean, lint-free cloth to clean the surface of the cartridge seal.
- Lubricate the surface of the seal with a silicone lubricant (Part No. MANITOU: 479292).
- Check visually the outer condition of the air filter and its attachments.
- Also check the condition and attachment of the hoses.
CLEAN Radiator core
IMPORTANT
In a polluting atmosphere, clean the radiator core every day.
Do not use a water jet or high-pressure steam as this could damage the radiator fins.
- Open the engine cover.
- Open the radiator side door 1.
- Using a soft cloth, clean the radiator in order to remove as much dirt as possible.
- Clean the radiator with a jet of compressed air directed from the inside towards the
outside. This is the only effective way of removing impurities (opposite direction
to the cooling air flow).
- Clean the radiator side door if required.
Â
50 H-WEEKLY MAINTENANCE OR EVERY50 HOURS OF SERVICE
3 - 14
1
647737 M1 (A102020)
TMM ... ST5 S1
To Next Page
Loading...
