Manitou TMM 20 K ST5 S1 - Engine Oil; Engine Oil Filter

REPLACE Engine oil **
REPLACE Engine oil filter **

IMPORTANT

** Only for the first 50 hours of service, and then every 500 hours of service or1 year.
Place the lift truck on level ground, let the engine run at idle for a few minutes, then
stop the engine.

IMPORTANT

Dispose of the drain oil in an ecological manner.
Tighten the oil filter by hand pressure only and lock the filter in place by a quarter turn.
DRAINING THE OIL
- Open the engine cover.
- Place a container under drain port 1 and unscrew the plug.
- Remove the filler plug 2 to ensure that the oil is drained properly.
REPLACEMENT OF THE FILTER
- Open the front casing.
- Remove engine oil filter 3 discard the filter and the filter seal.
- Clean the filter bracket with a clean, lint-free cloth.
- Lightly lubricate the seal and refit the new oil filter (FILTER CARTRIDGES AND
BELTS) on its holder.

IMPORTANT

Tighten the oil filter by hand pressure only and lock the filter in place by a quarter turn.
FILLING WITH OIL
- Refit and tighten the drain plug1 (tightening torque 33 to 37Nm).
- Fill up with oil (LUBRICANTS AND FUEL) through filler hole4.
NB: For this operation, we recommend you use a funnel fitted with a hose.
- Wait a few minutes to allow the oil to flow into the sump.
- Start the engine and let it run for a few minutes.
- Check the drain plug and the engine oil filter for leaks.
- Stop the engine, wait a few minutes and check the level between the MAX and
MIN marks on the dipstick 5.
- Top up the level if necessary.
- Close the engine cover and the front casing.
3 - 20
2
1
3
4
5
647737 M1 (A102020) TMM ... ST5 S1