Manitou TMM 20 K ST5 S1 - Replace; REPLACE Engine Oil Filter

REPLACE Engine oil
REPLACE Engine oil filter
Place the lift truck on level ground, let the engine run at idle for a few minutes, then stop the engine.

IMPORTANT

Dispose of the drain oil in an ecological manner.
Tighten the oil filter by hand pressure only and lock the filter in place by a quarter turn.
DRAINING THE OIL
- Open the engine cover.
- Place a container under drain port 1 and unscrew the plug.
- Remove the filler plug 2 to ensure that the oil is drained properly.
REPLACE Dry air filter cartridge
Pre-filtration cartridges are available for use in very dusty atmospheres ( FILTER
CARTRIDGES AND BELTS).
In very dusty atmospheres, with pre-filtration, the cartridge replacement interval must
be reduced to 250 hours.

IMPORTANT

Replace the cartridge in a clean location.
Never operate the lift truck with the air filter removed or damaged.
- Position the mast fully to the left.
- Turn off the lift truck's ignition.
- Open the engine cover.
- Open panel 1.
- Loosen the bolts 2 and remove the cover 3.
- Carefully remove the cartridge 4, taking care to avoid spilling the dust.
- Leave the safety cartridge in place.
- Carefully clean the following parts with a damp, clean, lint-free cloth:
• The inside of the filter and cover.
• The inside of the filter inlet bellows.
• The gasket surfaces in the filter and in the cover.
- Check pipes and connections between the air filter and the engine.
- Check the connection and condition of the clogging indicator on the filter.
- Before fitting check the condition of the new cartridge (
FILTER CARTRIDGES
AND BELTS).
- Introduce the cartridge into the filter axis, pressing on the edges and not the middle.
- Reassemble the cover, guiding the valve downwards.
Ân
500 H - ROUTINE SERVICING - EVERY 500 HOURS OF SERVICE OR 1 YEAR
3 - 22
1
1
2
2
3
4
647737 M1 (A102020) TMM ... ST5 S1