Manitou TMM 20 K ST5 S1 - REPLACE Fuel Filter Cartridge

REPLACEMENT OF THE FILTER
- Open the front casing.
- Remove engine oil filter 3 discard the filter and the filter seal.
- Clean the filter bracket with a clean, lint-free cloth.
- Lightly lubricate the seal and refit the new oil filter (FILTER CARTRIDGES AND
BELTS) on its holder.

IMPORTANT

Tighten the oil filter by hand pressure only and lock the filter in place by a quarter turn.
FILLING WITH OIL
- Refit and tighten the drain plug1 (tightening torque 33 to 37Nm).
- Fill up with oil (LUBRICANTS AND FUEL) through filler hole4.
NB: For this operation, we recommend you use a funnel fitted with a hose.
- Wait a few minutes to allow the oil to flow into the sump.
- Start the engine and let it run for a few minutes.
- Check the drain plug and the engine oil filter for leaks.
- Stop the engine, wait a few minutes and check the level between the MAX and
MIN marks on the dipstick 5.
- Top up the level if necessary.
- Close the engine cover and the front casing.
REPLACE Fuel filter cartridge

IMPORTANT

Carefully clean the outside of the filter and its holder, to prevent dust from getting into the system.
- Open the engine cover.
- Close the fuel tap 1 in position B.
- Unscrew the retaining ring 2, remove the bowl 3 and clean inside using a brush
soaked in clean diesel.
- Remove and discard the filter cartridge4.
- Refit the assembly with a new filter and seal previously lubricated with clean diesel
(FILTER CARTRIDGES AND BELTS).
- Open the fuel tap 1 in position A.
- Bleed the fuel supply circuit (FUEL SUPPLY CIRCUIT).
- Check the fuel hoses and cable ties.
3 - 23
2
3
4
5
2
3
4
2
B
1
A
647737 M1 (A102020) TMM ... ST5 S1