LUBRICATE Mast lifting chains
IMPORTANT
In case of technical faults, contact your dealer.
- Wipe the mast lifting chains 1 with a clean, lint-free cloth, then examine them
closely so as to detect any signs of wear.
- Vigorously brush the chains to get rid of any foreign matter, with a hard nylon
brush and clean diesel fuel.
- Rinse the chains by means of a paint brush impregnated with clean diesel fuel and
dry them with a compressed air jet.
- Lubricate the chains sparingly (
LUBRICANTS AND FUEL).
REPLACE Alternator belt
IMPORTANT
If the alternator belt has to be changed, check the tension again after the first 20 hours of operation.
Place the lift truck on level ground with the engine stopped and cold.
- Open the engine cover.
- Loosen screws 1 by two to three turns.
- Pivot the alternator assembly to release the belt 2 and replace it with a new one
(FILTER CARTRIDGES AND BELTS).
- Adjust the belt tension between the crankshaft and alternator pulleys.
- With normal thumb pressure (98 N), the tension should be between 7 and 9 mm.
- Retighten the screws 1.
NB: Take the opportunity provided by the removal of the belt to check that the
pulleys and bearings are working correctly (noise, friction, play, etc.).
REPLACE Hydraulic return oil filter cartridge
Stop the engine and release the pressure from the systems by operating the hydraulic
controls.
IMPORTANT
Thoroughly clean the outside of the filter and its surroundings before any operation to prevent any risk of polluting
the hydraulic system.
Do not operate the lift truck without the cartridge in place, as this would immediately damage the hydraulic
transmission system, the pump and the hydrostatic wheel motors.
- Lift the seat access hatch.
- Unscrew the filter head 1 with a wrench.
- Remove the hydraulic oil filter cartridge and replace it with a new one (FILTER
CARTRIDGES AND BELTS).
- Make sure that the cartridge is correctly positioned.
CHECK Fork wear *
* Contact your dealer.
1
3 - 24
1
2
1
1
1
647737 M1 (A102020)
TMM ... ST5 S1
To Next Page
Loading...
