Manitou TMM 20 K ST5 S1 - Wheel Nut Tightening Torques

Âp
2,000H - ROUTINE SERVICING - EVERY 2,000 HOURS OF SERVICE OR 4YEARS
ALSO PERFORM THE 500 HOUR AND 1,000 HOUR ROUTINE SERVICING OPERATIONS.
CHECK Wheel nut tightening torques
- Check the condition of the tyres, to detect cuts, blisters, wear, etc.
- Check the tightening torque of the wheel nuts with a torque wrench.
• Front and rear wheels: 250 Nm ± 25 Nm
CHECK Injection pump *
CHECK Injectors *
CHECK Radiator *
CHECK Water pump and thermostat *
CHECK Alternator and starter motor *
CHECK Hydrostatic transmission circuit pressure *
CHECK Governing start of the hydrostatic transmission *
CHECK Hydrostatic transmission cut-off operation *
CHECK Hydraulic circuit pressure *
CHECK Hydraulic circuit outputs *
CLEAN Hydraulic oil tank *
CHECK Bearings and articulation rings *
CHECK Condition of mast unit *
CHECK Mast lifting chains *
CHECK Chain rollers *
CHECK Mast guide rollers *
CHECK Mast bearing rollers *
CHECK Extender rollers *
CHECK Thickness of the mast wearing plates *
3 - 30
647737 M1 (A102020) TMM ... ST5 S1