Manitou TMM 20 K ST5 S1 - Occasional Operation; TOW Lift Truck

TOW Lift truck

IMPORTANT

The lift truck must be towed very slowly (less than 5km/h) and
for as short a distance as possible (less than 100m).
- Set the forward/reverse selector switch to neutral and immobilise the truck.
Hydrostatic disengagement (at the pump):
- Open the engine cover.
- Unscrew the high pressure limiters 1 and 2.
- Make a note of the clearance on the two high pressure limiters.
- Release the locknut 3.
- Tighten screw 4 until it is flush with the lock-nut 3.
Mechanical disengagement (at the wheel motors):
- All lift truck wheel motor brakes are applied.
- Remove the plug 5 from the brake cover.
- Take a jig 6 and an M12 nut. Screw a screw into the piston.
- Tighten nut 7 until the motor shaft turns freely.
- Switch on the hazard warning lights.
- After towing, proceed in the reverse order to lock the high pressure limiters.
- Do not forget to fit a new plug 5.
Â
OCCASIONAL OPERATION
3 - 34
x
1
2
3
4
5
6
7
647737 M1 (A102020) TMM ... ST5 S1