EasyManua.ls Logo

Manitowoc National Crane NBT45-1 - Page 192

Manitowoc National Crane NBT45-1
206 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11-12 3-29-2018 Control # 610-00
SAFETY DECALS NBT40-1 SERIES OPERATOR MANUAL
25
DANGER
An untrained operator of equipment subjects himself and others to
Death or Serious Injury.
You must not operate this equipment unless:
You are trained and familar with the safe operation of this
equipment.
You read and understand and follow the safety and operating
recommendations contained in the equipment manufacture’s
manuals, your employers work rules and applicable government
regulations.
You are sure that all safety signs, guards and other safety
features are in place and in proper condition.
26
CAUTION
Front Stabilizer Operation
Set Front Stabilizer After Leveling Crane
27
DANGER
Electrocution Hazard
To Avoid Death or Serious Injury keep all parts of the equipment,
rigging and load at least 20 feet (6 meters) away from any energized
power line. You must follow the OSHA requirements set forth in
29CFR1926.1407 through 1926.1411.
This equipment is not designed or equipped for use within 10 feet (3
meters) of energized power lines. [Refer to 29CFR1926.1410 Table A].
If operation within 10 feet (3 meters) or any power lines cannot be
avoided, the power utility MUST be notified and the power lines Must
be de-energized and grounded before performing any work.
If contact is ever accidentally made with a power line and any part of
this equipment, its rigging or load , NEVER touch the equipment or
even approach or come near the equipment.
Electrocution can occur even without direct contact with the
equipment.
28
DANGER
Failure to maintain the anti-two-block System will Result in Death
or Serious Injury
The anti-two block system on this crane must be tested daily for
proper operation, see owners manual for detail.
When the anti-two-block system is activated the boom telescope
and winch up function will cease operation. To restore normal
functioning the winch down function or boom retract function
must be operated until the loadline block allows the anti-two
block sensing weight at the sheave case to hang freely.
Item
Decal Explanation of Decal

Table of Contents

Related product manuals