42
SETTINGS
CHANNEL
FREQUENCY
INTENSITY
A
HIGH*
8-9
B
HIGH*
8-9
Especially for back pain, reaching the target
intensity level of 8-9 will help produce much more
signifi cant and lasting relief. It may take some time to
slowly reach these target levels.
Turn the intensity levels up slowly until the “buzzing”
feels very strong and intense, but not above your
tolerance (this will be different for everyone, but is
commonly an intensity level of around 4).
Wait 1-2 minutes. As your body acclimates, the signal
will not feel as strong. At this time, turn the intensity
level up slowly again until it feels very strong and
intense, but not above your tolerance.
Wait a few minutes for your body to acclimate and
repeat the process until you eventually reach the target
intensity range or as high as possible.
The signal should feel very strong and intense, but
never continue if there is discomfort. If you need to get
up and move during treatment, we recommend turning
down the intensity until back in a relaxed position.
LOWER BACK PAIN
*If congestion is primary concern
use Low Frequency. If pain is primary
and caused by other factors use High
Frequency, or use half and half.
**Once pain has been substantially
reduced, use Low Frequency for half
of treatment.
MPRO_19-003_MPP_MANUAL_FINAL_IMAGES_C8.5.indd 42MPRO_19-003_MPP_MANUAL_FINAL_IMAGES_C8.5.indd 42 9/1/20 5:43 AM9/1/20 5:43 AM
To Next Page
Loading...
