51
Visit www.marcpro.com for
more info, tips, tricks and
best practices
Troubleshooting:
If the battery gauge starts fl ashing during the
treatment, the charge level of the batteries is getting
low. Stop the treatment session and recharge the
device.
If the signal feels weak or intermittent and/or device
says “Check Leads and Pads”:
• Check to make sure all pads have a good
connection to the skin.
•It may be time to change to a new set of electrodes
(see “Electrode Care”).
If the unit is powered on and the LCD screen does not
turn on, check that the charger is unplugged from the
wall and the back of the device.
If this had been done and there is no change, or if the
unit does not seem to be holding its 10 hour charge
time between treatments, please contact Marc Pro.
The battery may need to be replaced.
Technical Data:
+ Voltage 0-35V
+ Frequency 1-70Hz
+ Pulse Duration 5ms; 1ms at 50% of max
amplitude
*tests conducted under 1K load
+ Current 0-35mA
+ Bi-phasic waveform
Cleaning Your Unit:
To clean your Marc Pro Plus, use a cloth and an
alcohol-based cleaning product, which does not
contain solvents.
Storage & Transport Conditions:
The Marc Pro Plus contains rechargeable
batteries. The storage conditions must
not exceed the following fi gures: Storage
temperature: from -4° F to 113° F, -20° C to 45° C
Max. relative humidity: 75%
Atmospheric pressure: from 700 hPa to 1060 hPa
Disposal:
For environmental protection, the device,
the battery and its accessories have to be
disposed of properly.
Type BF Applied Part
!
Note Operating Instructions
MPRO_19-003_MPP_MANUAL_FINAL_IMAGES_C8.5.indd 51MPRO_19-003_MPP_MANUAL_FINAL_IMAGES_C8.5.indd 51 9/1/20 5:43 AM9/1/20 5:43 AM
To Next Page
Loading...
