16
Treatment Modes – Pre-Set (default) or Manual (advanced users only)
The Marc Pro Plus comes in a simple to use and recommended “pre-set mode”. The Low frequency button will deliver the rhythmic
non-fatiguing muscle contractions used for conditioning and recovery. The High frequency button will deliver a very strong, but soothing
buzzing sensation. This can provide additional pain control sometimes needed in trouble spots like the back and joints.
Though it’s not necessarily recommended advanced users can put the Marc Pro Plus device into “manual mode” and choose between
over 70 frequency options and experiment with the results. If you nd a frequency you like best you can even program those to be your
personalized pre-sets. This gives the advanced user or experimenter total exibility and control over the stimulation they receive.
When the Marc Pro Plus device is powered on the LCD prompts the user to select a frequency for each channel. The device is
delivered in Pre-Set mode; which we highly recommend. Selecting Low will put that channel at 2 Hz. Selecting High will put that channel
at 60Hz
How to Toggle between Standard and Pre-Set Mode:
To switch modes simply hold down the two inner frequency buttons while powering on the device. Repeating this process will toggle
between the two modes. The LCD screen will identify which mode you are in.
In manual mode the frequency selection buttons at the bottom of the interface can be used to select any frequency from 1Hz to 70Hz.
In Pre-Set mode the “low” button defaults to a recommended 2Hz and the “high” button defaults to recommended 60Hz. However if
experimentation with manual mode results in your preference for particular frequencies you can choose any frequency to be your “pre-set”
Setting the frequency for Pre-Set Mode:
Holding down the two frequency buttons on the left side of the device while powering up will put the device into set mode. Use the
Channel A frequency selection buttons to choose the pre-set frequency that you would like for the low button and use the Channel B
frequency selection buttons to choose the pre-set frequency that you would like for the high button. (Default is 2Hz for low button and
60Hz for high button). Once you have chosen your presets; power off the device. The device will remember these pre-sets until they
are changed following the same procedure.
To Next Page
Loading...