Marea B59003 - Sleep Monitor; Remote music player; Alarm clock (only set via APP); Timer

The last 8 training records can be displayed. The records will be displayed in chronological
order and can be viewed by sliding up and down.
3.9 Sleep Monitor
The default sleep monitor starts at 21:00 pm and ends at 7:30 am the next day. If the watch
is worn while sleeping, you can check the sleep time on the watch in the following morning.
If the smart watch is paired with the phone, the sleep data will be synchronized automatically
(or manually) with the application.
Note: The smart watch is able to automatically identify the sleeping status. There may be
differences between the detected data and the actual data because the watch may still be
under the detection process. The watch will display the detected result of the whole night,
which will be identical with the actual sleep data, once it finishes the monitoring. There may
be some deviation with the actual sleeping status due to the change in different sleep modes.
3.10 Remote music player
3.10.1 If the watch has not been paired with your phone, an ‘unconnected’ message will
pop up when you click the ‘Music’ icon, and it will automatically exit without any actions
after 2 seconds.
3.10.2 After pairing the watch with your phone, you can enter the music player function
of the watch to control the phone’s music player. There may be some compatibility
problems due to the variety of music players. Usually the watch can control your phone’s
music player directly, but some player may need to be opened manually before been
remotely controlled by the watch.
3.10.3 The watch can pause, play and switch to the previous or next song, but it does not
show the name of the song and cannot adjust the volume.
3.11 Alarm clock (only set via APP)
The application supports setting a maximum of 5 alarms. Upon entering the “Alarm” function,
the display will show 2 alarms, swipe up to see more alarms, if any.
3.12 Timer
Set target time, then click start icon. The message “timed out” will pop up on the screen and
the watch will vibrate.
3.13 Stop watch
Click start icon to start counting. Click the green icon to stop, click the blue icon to set a lap