Need help?Do you have a question about the Mark Bass LITTLE MARK III and is the answer not in the manual?
General| Technology | Solid State |
|---|---|
| Effects Loop | Yes |
| Headphone Output | Yes |
| Power Output | 500W at 4Ω, 300W at 8Ω |
| Inputs | 1 x 1/4" (instrument), 1 x XLR (line) |
| Outputs | 1 x Speakon Speaker Output, 1 x XLR Line Out |
| EQ | 4-band EQ |
| Controls | Gain, Master Volume |
| Amplifier Type | Bass Amplifier |
Remove six black, three yellow knobs and nine silver hexagonal nuts from the preamp.
Disconnect four preamp connectors and remove three screws.
Remove four connectors, cut two ties, and remove six screws from the poweramp.
Remove two front panel screws, four faston connectors, and the power switch.
Remove four hexagonal nuts, jack screws, fan screws, back panel screw, and ground nut.
Press the top and bottom ends of the AC power jack to remove it from the panel.
Details the default parallel connection setup for the effects loop.
Details how to modify the effects loop to run in a series configuration.
To Next Page
