15
LAMP REPLACE
During the replacement of the lamp is forbidden to touch it without protection to avoid the greasy dirt
stains filament.
Disconnect the power. Before replace lamp, fixture need 20 minutes for lamp cooling. Fasten the head
with Y axis protect lock in 60 ° position.
1. Use phillips screwdriver to open the light body cover
2. After open the cover, you can see the lamp inside, please wait the lamp be cool after used but not
touch it in hot status
3. One hand press the lamp holder, another hand hold the lamp, and pull out the wire
4. After take apart the lamp, please check the inside glasses, clear it will make the light better effect
5. Installed the lamp after replaced
1 2 3 4 5
To Next Page
Loading...