Single Multi Trailer Options
SuperGlides install.
1. Slide wide SuperGlides into siderail extrusion, 4 pieces will fit, then slide on the
SuperGlide extrusion.
2. Rivet the extrusion down 1 inch from each end. Then starting at the back of the trailer at
29.5” then 59” then again at 88.5” for a total of 5 rivets per length of SuperGlide
extrusion. Then rivet the end of the front and rear glide as per picture below, it is not
necessary to rivet any of the middle 2 glides.
OWNER’S MANUAL / www.marlonproducts.com
To Next Page
Loading...