OUTDOOR INSTALLATION
To install the vessel outdoors, a flat level concrete reinforced pad at a mini-
mum thickness of 6” - 8” or 152mm - 203mm is required.
Placement of the vessel on pavers, gravel, or dirt is not approved and will
void the warranty. The reinforcing material should be attached to a #8 AWG
bonding wire per national and local electrical code (#6 AWG in Canada).
INDOOR INSTALLATION
There are special requirements if you place your vessel indoors. A flat level
concrete reinforced pad at a minimum thickness of 6” - 8” or 152mm -
203mm is required. Flooring material must provide adequate traction when
wet. Proper drainage is essential to prevent water puddling. Proper venti-
lation to the area is required. The addition of a ventilation system is recom-
mended. Please see your contractor for details.
OUTDOOR & PATIO INSTALLATION
To Next Page
Loading...
