Mars Low Profile Series 2-CSI-Spec Revised 2/3/2021
MARS AIR SYSTEMS, LLC
23 34 33 – 5
a. Unheated: 8-7/8 inches deep by 8 inches high (including discharge
nozzle) by width of unit.
b. Electric Heated: 11-3/4 inches deep by 8 inches high (including
discharge nozzle) by width of unit.
c. Hot Water/Steam Heated: Depth 11-3/4 inches by 8 inches high
including discharge nozzle by width of unit plus 10 inches for manifolds
2. Mounting:
a. Unheated Inside Mount.
b. Heated Inside Mount.
c. Unheated Outside Mount.
d. Mount Location Indicated.
3. Material:
a. Provide 18- and 20-gauge electro or hot dipped galvanized steel sheet
housing conforming to ASTM A 591 and/or ASTM A 653.
b. Provide type 304 stainless steel housing with brushed finish. ASTM A
240/A 240M.
4. Air Inlet Grille and Filters:
a. Location: Front.
b. Type: Fixed air intake grille.
1) Filter: Aluminum mesh, 1/4 inch (6.4 mm), washable.
c. Type: UV Only as follows
1) UV: UVC & UVV germicidal and odor elimination, 4” UV
section with disposable UV bulbs
5. Discharge: Provide integral discharge nozzle specified.
6. Finish and Color: Provide with, no VOC, corrosion resistant polyurethane
powder coated finish for sheet metal housings.
a. Obsidian Black.
b. Pearl White.
c. Titanium Silver.
d. Stainless Steel.
C. Environmental Air Curtains: Models for Heights up to 8 feet (2438 mm) for
Environmental Separation and Temperature Control and up to 7 feet (2133 mm) for
Flying Insect Control.
1. Discharge Nozzle: Adjustable air foil vanes with a plus/minus 40-degree sweep
front to back.
2. Air Velocity at Nozzle:
a. LPV225-1: 25 Inch (635 mm) Wide Units: 1800 feet/min (9.1 m/s) single
1/6HP motor/fan assembly.
b. LPV236-1: 36 Inch (915 mm) Wide Units: 1800 feet/min (9.1 m/s) single
1/6HP motor/fan assembly.
c. LPV242-1: 42 Inch (1067 mm) Wide Units: 1800 feet/min (9.1 m/s)
single 1/6HP motor/fan assembly.
d. LPV248-1: 48 Inch (1220 mm) Wide Units: 1800 feet/min (9.1 m/s)
single 1/6HP motor/fan assembly.
e. LPV260-1: 60 Inch (1524 mm) Wide Units: 1800 feet/min (9.1 m/s)
single 1/6HP motor/fan assembly.
To Next Page
Loading...
Need help?
General
