Need help?Do you have a question about the Marshall Amplification HAZE MHZ15 and is the answer not in the manual?
General| Brand | Marshall Amplification |
|---|---|
| Model | HAZE MHZ15 |
| Category | Music Equipment |
| Language | English |
General information regarding mains input, fuse, and electrical supply compatibility for Haze amplifiers.
Step-by-step guide for connecting speakers, setting controls, and powering up the amplifier safely.
Specific instructions pertaining to the Haze 40 amplifier model, including the standby switch.
Connect your guitar using a screened guitar cable. Ensure good quality for optimal sound.
Enables the Bright function on Normal and Overdrive channels for added tonal character.
Engages Boost for the Normal channel, providing more gain and vintage tone.
Adjusts the volume of the Normal Channel, providing clean to overdriven tones.
Selects between Normal and Overdrive channels. Disabled when footswitch is connected.
Engages Boost for the Overdrive channel for increased gain and lead territory.
Controls preamp signal level, affecting the amount of distortion available.
Adjusts signal to the power amp, controlling volume and power amp distortion.
Interactive Bass, Middle, and Treble controls for tonal shaping.
Manages reverb and effects settings, storing them per channel for recall.
Sets the amount of signal sent to the reverb, can be globally disabled.
Controls depth of chorus/vibe or level of echo, can be globally disabled.
Adjusts modulation speed (Chorus/Vibe) or delay time (Echo).
Cycles through Echo, Vibe, Chorus effects, or turns them off.
Used with Power Switch to warm up valves or mute the amp.
Main On/Off switch for the amplifier's mains power.
Connects the detachable mains lead; includes a fuse for protection.
Protects the amplifier's high-tension circuitry; must be the correct value.
Provides a speaker-cabinet-emulated output for PA or recording.
Connect speaker cabinets; observe impedance matching warnings to prevent damage.
Bypasses the effects loop circuitry when 'out'.
Connect external effects processors or pedals for enhanced sound.
Connects the 2-way footswitch for channel and effect control.
Main On/Off switch for the amplifier's mains power.
Manages reverb and effects settings, storing them per channel for recall.
Cycles through Echo, Vibe, Chorus effects, or turns them off.
Adjusts modulation speed (Chorus/Vibe) or delay time (Echo).
Controls depth of chorus/vibe or level of echo.
Sets the amount of signal sent to the reverb, can be disabled per channel.
Bass, Middle, and Treble controls for tonal shaping.
Controls preamp signal level, affecting the amount of distortion available.
Adjusts volume and power amp overdrive for the Overdrive Channel.
Adds extra bite to the sound on the Overdrive channel.
Selects between Normal and Overdrive channels. Disabled when footswitch connected.
Adjusts volume for the Normal Channel, providing clean to overdriven tones.
Connect your guitar using a screened guitar cable. Ensure good quality.
Connects the 2-way footswitch for channel and effect control.
Connect speaker cabinets; observe impedance matching warnings to prevent damage.
Protects the amplifier's high-tension circuitry; must be the correct value.
Connects the detachable mains lead; includes a fuse for protection.
Recommended settings for a bluesy tone with single coil pickups and reverb.
Recommended settings for a raw crunch overdrive sound.
Recommended settings for high-gain soloing with reverb and delay.
Recommended settings for a clean tone with reverb on the Normal channel.
Recommended settings for a crunchy tone on the Normal channel.
Recommended settings for a lead tone with reverb and delay.
Important safety advice and instructions for safe operation and maintenance.
Instruction to retain the manual for future reference and safety.
To Next Page