1. Please check whether lens mount type is C mount or CS mount.
2. CS mount type: Mount the lens after removing the rubber cap.
C mount type: attach the C mount ring and mount the lens.
3. Go to the camera setup and set the LENS mode as ESC.
1. Mount the lens as described in the manual lens connection.
2. Connect the auto IRIS lens connector to the connector on IRIS port
on the the rear panel.
3. Go to the camera setup and set the LENS mode as DC IRIS
SDI
IRIS
【
1
】
2
】
【4】
【5】
【6】
【3】
【1】OSD Control
【2】
【3】
SDI Out
【4】POWER LED
【5】HDMI
【6】MAIN I/O
IRIS Port
C mount ring
CS mount
C mount ring
IRIS Port
56
60
CS mount
【
HDMI
POWER
I/O
SDI
IRIS
HDMI
POWER
I/O
MAIN I/O
12VDC
AUDIO
RS-485
OSD Control
SPECIFICATIONS
Image Sensor 1/3” Progressive CMOS (Approx. 2.1 mega)
Scanning System 16:9 Progressive
Sync. System Internal
Effective Pixel 1920(H) x 1080(V)
Min. Illumination 0.2Lux (Day), 0.1Lux (Night), 0.005Lux (DSS on)
Horizontal Resolution 1,000TVL
Optics Lens C/CS Mount, DC-IRIS
WDR/BLC
HLC (High Light compensation)
Exposure Auto / Manual
Auto (3,000°K~8,000°K)
ATW (1,900°K~11,000°K)
Manual
Day & Night System AG
C / TDN (ICR)
NTSC: 1/30~1/30000
PAL: 1/25~1/30000
DSS ( ~X64)
Privacy Mask, Image Mirror, 3DNR, Flickerless
Sharpness, Defog, DIS (Digital Image Stabilizer)
Motion Detection, DSS (Digital Shutter Speed)
SMPTE 292M (1.485Gbps)
1080p@25/30 or 29.97
1080i@50/60 or 59.94
720p@50/60 or 59.94
720p@25/30
SMPTE 424M (2.97Gbps)
1080p@50/60 or 59.94
800mVp-p, 75Ω, Unbalanced Generator (Single-En
ded)
Bit Depth: 16,20,24,32Bits. 48KHz sample rates
Gain : -12dB ~ 59.5dB
PELCO-P/D, SONY-VISCA Protocol
8Bits Data, 1Stop Bit, No Parity, 2400~115200bps
Operation Temperature -10℃ ~ 50℃
Power Input 12VDC (7VDC to 15VDC)
Power consumption Max 6W
Dimensions (W X H X D) 60 X 60 X 56mm / 2.36 X 2.36 X 2.20Inches
Net Weight Approx. 160g/0.35Lbs (Without Lens)
Video
Output
SDI (BNC)
Control RS-485
General
HDMI (HDMI Type A)
MIC
Input
CV345
Sensor
Functions
Back Light Compensation
White Balance
Electronic Shutter
Functions
60
WARNING
!
Do not use the camera if fumes, smoke or a strange odor is emitted
from the unit, or if it seems to not function correctly. Disconnect the
power source immediately and consult your supplier.
CAUTION
Always follow the instructions in the installation guide when
applying power. Fire and equipment damage can occur if power
is applied incorrectly. For the correct power supply, refer to the
CAUTION
Do not install or operate in small, unventilated areas. Heat build up
CAUTION
To prevent damage, do not drop the camera or subject it to strong
CAUTION
If installed close to a TV, radio transmitter, magnet, electric motor
interfere with or distort
the image.
CAUTION
Whether or not the camera is used outdoors, never point it toward
the sun. Use caution when operating the camera in the vicinity of spot
CAUTION
Do not use the camera in extreme environments where high
temperatures or high humidity exists. Use the camera under
conditions where temperatures are between 14°F ~ 122°F (-10°C ~
50°C), and humidity is below 90%.
shock or vibration.
LCDracks.com
CV345-CSB/CS Quick Start Guide
Marshall Electronics
Rear Panel Video/Power Connection
Manual Iris Lens Connection
Auto Iris Lens Connection
Specifications
Dimensions
Features
· 2.5 Megapixel 1/3-inch CMOS Sensor
· CS/C Mount with DC-Auto Iris (lens sold separately)
· CV345-CSB: 1920x1080p59.94/29.97, 1920x1080i59.94,
1280x720p59.94/29.97fps
· CV345-CS: 1920x1080p60/50/30/25, 1920x1080i60/50,
1280x720p60/50/30/25fps
· Lemo-style (I/O) connector contains: RS-485(+/-), 12V power
connector & TRS microphone input with 2.5V power supplied
· 3G/HD-SDI (BNC) & HDMI (full size-v1.3) built into rear panel
· Audio Mic 3.5mm TRS Stereo input embedding w/ 2.5V power supplied
· OSD Menu Joystick, RS-485 (Pelco/Visca)
· 12VDC
Full-HD (3G/HD-SDI) 2.5MP Compact Broadcast
Camera with AUDIO + HDMI (CS/C mount w/ Auto-Iris)
To Next Page
Need help?
General